Dscp-To-Ieee802.1P Priority Mapping; Configuring Dscp Settings; Table 47 Default Dscp-Ieee802.1P Mapping - ZyXEL Communications ZyXEL Dimension ES-2024 User Manual

ES-2024 Series User's Guide
Table 46 DiffServ (continued)
LABEL
*
Active
Apply
Cancel

21.3 DSCP-to-IEEE802.1p Priority Mapping

You can configure the DSCP to IEEE802.1p mapping to allow the switch to prioritize all
traffic based on the incoming DSCP value according to the DiffServ to IEEE802.1p mapping
table.
The following table shows the default DSCP-to-IEEE802.1P mapping.

Table 47 Default DSCP-IEEE802.1p Mapping

DSCP VALUE 0 – 7
IEEE802.1P

21.3.1 Configuring DSCP Settings

To change the DSCP-IEEE 802.1p mapping click the DSCP Setting link in the DiffServ
screen to display the screen as shown next.
141
DESCRIPTION
Use this row to configure all the ports at once.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port by port basis.
Note: When you make changes in this row, the changes are copied to
all the ports as soon as you make them.
Select this option to enable DiffServ on the port.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to start configuring this screen again.
8 – 15 16 – 23
0 1 2
24 – 31 32 – 39 40 – 47
3 4 5
Chapter 21 DiffServ Code Point
48 – 55 56 – 63
6 7