ZyXEL Communications ZyXEL Dimension ES-2024 User Manual page 111

ES-2024 Series User's Guide
Table 31 Link Aggregation Control Protocol: Configuration (continued)
LABEL
*
Group
LACP Timeout Timeout is the time interval between the individual port exchanges of LACP packets in
Apply
Cancel
111
DESCRIPTION
Use this row to configure all the ports at once.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select the trunk group to which a port belongs.
order to check that the peer port in the trunk group is still up. If a port does not respond
after three tries, then it is deemed to be "down" and is removed from the trunk. Set a
short timeout (one second) for busy trunked links to ensure that disabled ports are
removed from the trunk group as soon as possible. Select either 1 second or 30
seconds.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 15 Link Aggregation