Table of Contents
Advertisement
Figure 3-2. Removing Modular Power Supply from Power Supply Shuttle
2
1
1
Power Supply Shuttle
Installation
Ensure that there is no visible damage to the new power supply assembly. Verify that the housing
and connector on the new power supply assembly have no foreign material inside. Install the
new power supply assembly into the opening in the shuttle in the reverse order of removal.
Replace and tighten the four screws with a Phillips screwdriver or by hand.
After installing the power supply assembly, slide the power supply shuttle into the opening in
the rear of the chassis. Tighten the eight screws with a Phillips screwdriver.
Configuration
The fan-speed selector switch is on the rear panel of the power supply shuttle. Refer to
Figure 1-2,
Rear View of the NI PXIe-1085 Series
Select High for maximum cooling performance (recommended) or Auto for quieter operation.
Set the Inhibit Mode switch to the Default position.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
3
2
Modular Power Supply Handle
Chassis, to locate the fan-speed selector.
NI PXIe-1085 Series User Manual
3
Modular Power Supply
© National Instruments | 3-5
Advertisement
Table of Contents
