Installing Peripheral Modules - National Instruments PXI Express PXIe-1085 Series User Manual

Chapter 2 Installation and Configuration
Figure 2-5 shows a PXI Express system controller installed in the system controller slot of a
NI PXIe-1085 Series chassis. You can place CompactPCI, CompactPCI Express, PXI, or
PXI Express modules in other slots depending on the slot type.
Figure 2-5. NI PXI Express System Controller Installed in a NI PXIe-1085 Series Chassis
1
2
3
1 NI PXIe-1085 Series Chassis

Installing Peripheral Modules

The NI PXIe-1085 Series chassis has been designed to accept a variety of
Caution
peripheral module types in different slots. To prevent damage to the chassis, ensure
that the peripheral module is being installed into a slot designed to accept it. Refer to
Chapter 1, Getting
This section contains general installation instructions for installing a peripheral module in a
NI PXIe-1085 Series chassis. Refer to your peripheral module user manual for specific
instructions and warnings. To install a module, complete the following steps:
1. Connect the AC power source to the PXI Express chassis before installing the module. The
AC power cord grounds the chassis and protects it from electrical damage while you install
the module.
2. Ensure that the chassis is powered off.
2-8 | ni.com
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2 NI PXI Express System Controller
Started, for a description of the various slot types.
3 Injector/Ejector Rail