Table of Contents
Advertisement
Chapter 2
Installation and Configuration
The Ethernet controller can perform automatic crossover, thus eliminating the
Note
need for crossover cables.
Through the remote monitoring Ethernet interface of the chassis, you can access a web page with
information about the current chassis operating parameters. You can access this page in most
browsers. Enter the IP address or hostname currently assigned to the chassis into the browser's
address bar. Figure 2-7 shows an example of the web page.
Figure 2-7. Chassis Configuration Web Page
The Ethernet connector has two LEDs that indicate the current status of the Ethernet link.
Table 2-1 describes the behavior of these LEDs.
LED
State
ACT/Link
Off
Steady green
Blinking green
10/100
Off
Steady green
Default Configuration Settings
The chassis ships from the factory with the following default configuration settings:
•
DHCP with Auto IP fallback
•
Default hostname as printed on the product label
2-10 | ni.com
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 2-1. Ethernet LED Behavior
Description
Link is not established.
Link is established.
Chassis is communicating with another device on the
network.
10 Mbps data rate is selected.
100 Mbps data rate is selected
Advertisement
Table of Contents
