Table of Contents
Advertisement
2.4.1 Reset the Multy Device Back to Factory Default Settings
Follow the steps below for a factory reset.
WSQ60 / WSQ50 / WSQ20:
Make sure the LED light on the top panel is not blinking white.
1
Press the reset button for at least 5 seconds or until the LED starts to blink red.
2
WSR30:
Press the reset button for at least 5 seconds or until the LED starts to blink amber.
WSM20:
Press the reset button for at least 5 seconds or until the LED starts to blink yellow.
WSQ65:
Press the reset button for at least 3 seconds or until the LED starts to blink green.
2.5 LED On/Off Switch
WSM20:
Press the LED on/off switch to turn on or off LED lights.
Chapter 2 Hardware
Multy WiFi System User's Guide
33
Advertisement
Table of Contents
