Table of Contents
Advertisement
6. Click OK to close the Network window.
7. Turn on your Prestige and restart your computer when prompted. Insert the Windows CD if prompted.
Verifying TCP/IP Properties
1. Click Start and then Run. In the Run window, type "winipcfg" and then click OK to open the IP Configuration window.
2. Select your network adapter. You should see your computer's IP address, subnet mask and default gateway.
2.2.2 Setting up Your Windows NT/2000/XP Computer
Configuring TCP/IP
1. Click Start, Settings, Network and Dial-up Connections and right-click Local Area Connection or the connection you want
to configure and click Properties. For Windows XP, click start, Control Panel, Network and Internet Connections and then
Network Connections. Right-click the network connection you want to configure and then click Properties.
2. Select Internet Protocol (TCP/IP) (under the General tab in Win XP) and click Properties.
3. The Internet Protocol TCP/IP Properties window opens. Click Obtain an IP address automatically.
4. Click Obtain DNS server automatically.
5. Click Advanced, IP Settings tab and remove any installed gateways, then click OK.
6. Click OK to save and close the Internet Protocol (TCP/IP) Properties window.
7. Click OK to close the Local Area Connection Properties window.
8. Turn on your Prestige and restart your computer (if prompted).
Verifying TCP/IP Properties
1. Click Start, Programs, Accessories and then Command Prompt.
2. In the Command Prompt window, type "ipconfig" and then press ENTER. The window displays information about your IP
address, subnet mask and default gateway.
2.2.3 Setting up Your Macintosh Computer
Configuring TCP/IP Properties
1. Click the Apple menu, Control Panel and double-click TCP/IP to open the TCP/IP Control Panel.
2. Select Ethernet from the Connect via list.
3. Select Using DHCP Server from the Configure list.
4. Close the TCP/IP Control Panel.
5. Click Save if prompted, to save changes to your configuration.
6. Turn on your Prestige and restart your computer (if prompted).
Verifying TCP/IP Properties
Check your TCP/IP properties in the TCP/IP Control Panel.
2.3
Factory Default Settings
The
is configured as a IP sharing router with NAT and DHCP enabled and with following factory default.
P964 APR
Items
LAN IP Address
Subnet Mask
DHCP IP Pool
Web user username
Web user password
The default might be different from different cable operators. Please consult with your cable Internet service provider for
any change.
Hardware Installation
Table 2-2 P964 APR factory default
Settings
192.168.1.1
255.255.255.0
192.168.1.33 – 192.168.1.64
user
1234
P964 APR Cable Router with 802.11g Access Point
2-3
Advertisement
Table of Contents
