ZyXEL Communications WAH3004 Quick Start Manual

Quick Start Guide

Hardware Installation

1
Slide open the cover (B) from back of the USB dongle.
1
1
Insert a SIM card and a micro SD card (optional). Slide close the
2
back cover (B).
1
Remove the cap (A) from the USB dongle and insert it into the USB
3
port of your computer.
1
Check the Windows taskbar or the Mac pop-up window to see if the
4
USB dongle is installed properly.

Driver Installation

For Mac:
The driver will be automatically installed on your computer.
For Windows:
The driver will be automatically installed on your computer. To see the device,
navigate to the Device Manager window (Start > Control Panel > Device
Manager) and click Network adapters. You will find a "Remote NDIS based
Internet Sharing Device" as shown in the below screen
If the driver failed to install, remove and plug in the WAH3004 again. Then go
and find a removable disk named Network Connection RNDIS on your
computer instead. Double-click Install to install the driver.
1/2
WAH3004
USB 3G Modem Router
A
Insert the SIM card (and SD card) with the slanted side matching the
card holder and the metal contact area facing downwards into the
slot, and then push the SIM card (and SD card) as far as possible.
Copyright © 2015 ZyXEL Communications Corp. All Rights Reserved
LED Information
Wi-Fi LED
Green on: Wi-Fi enabled
Green blink: Data transmitting
Signal LED
Red on: SIM error/No service
Green on: 2G/3G network
Green blink: Data transmitting
B