Manage Custom Static Routes - NETGEAR MR90 User Manual

5. Select the Enable VLAN/Bridge Setup check box.
The page expands.
6. Select the By bridge group radio button.
The page expands.
7. Select the Port1 check box:
8. Click the Apply button.
Your settings are saved.

Manage custom static routes

For almost all Internet traffic, routes are automatically and dynamically selected. You
can also set up a fixed, static route. Typically, you only need to add static routes when
you have more than one router or multiple IP subnets on your network.
As an example of when a static route is needed, consider the following case:
• Your main Internet access is through a cable modem to your ISP. The cable modem
is connected to your router.
• Your network also includes an ADSL router that you use to access a remote office
site. This ADSL router is connected to a DSL modem, which is used on-demand only.
• Your LAN subnet is 192.168.1.0, and the ADSL router's address on your LAN is
192.168.1.100.
• The public IP address range at the remote office site is 134.177.0.0.
When you set up your router, two implicit static routes were created:
1. A default route was created between your router and the cable modem that connects
to your ISP.
2. A second static route was created between your router and your LAN for all
192.168.1.0 addresses.
With this configuration, if you try to access a device on the 134.177.0.0 network at the
remote office site, your router forwards your request to your ISP. In turn, the ISP forwards
your request to the remote office site, where the firewall will deny the request.
In this situation, you must define a static route, telling your router to access 134.177.0.0
addresses through your ADSL router at its LAN address of 192.168.1.100.
Manage Network Settings
Nighthawk Tri-band Mesh WiFi 6E
94 User Manual