Sony HSR-X200 Operating Instructions Manual page 50

Preparations
2
Turn the Jog dial to set to USE and turn the Shuttle
dial clockwise.
3
Set when to switch to summer (daylight savings)
time on the ON line.
WEEK: What day of which (first, second, third,
fourth, or last) week in the specified month on
which to switch
MONTH: Month in which to switch
TIME: Time (hours:minutes) when to switch
4
Similarly set when to return to the standard time on
the OFF line.
Adjusting the time using the CLOCK IN/
OUT terminals
To adjust the built-in clock of this unit and/or the
clocks of another connected HSR-X200/X200P units
using the CLOCK IN/OUT terminals on the rear panel,
set the hours and minutes for ADJUST. TIME of EXT.
CLOCK SET.
The output at the CLOCK OUT terminal will drop to
0 V at the time you specify here.
When the CLOCK IN terminal is short-circuited to the
COM terminal, the built-in clock will be set to the time
you specify here, and the output at the CLOCK OUT
terminal will drop to 0 V at the same time.
Be sure to set ADJUST. TIME of EXT. CLOCK SET
to the same time on all the connected HSR-X200/
X200P units.
When the settings are completed
Press the EXIT/OSD button to exit the menu.
50
(GB)
CLOCK IN/OUT connection examples
1: When adjusting the time by using an external
switch
HSR-X200/X200P
COM
COM
RS-232C
HSR-X200/X200P
COM
COM
RS-232C
HSR-X200/X200P
COM
COM
RS-232C
External switch
CLOCK
COM IN
NON REC OUT WARNING OUT
ALARM CLOCK
RESET ALARM
IN OUT COM IN OUT FULL FULL
-AC IN
COM COM IN OUT COM COM
A B REMOTE SW OUT
SERIES
RS485
RS485
TERMINATE
ON
OFF
COM
CLOCK
OUT
CLOCK
COM IN
NON REC OUT WARNING OUT
ALARM CLOCK
RESET ALARM
IN OUT COM IN OUT FULL FULL
-AC IN
COM COM IN OUT COM COM
A B REMOTE SW OUT
SERIES
RS485
RS485
TERMINATE
ON
OFF
COM
CLOCK
OUT
CLOCK
COM IN
NON REC OUT WARNING OUT
ALARM CLOCK
RESET ALARM
IN OUT COM IN OUT FULL FULL
-AC IN
COM COM IN OUT COM COM
A B
REMOTE SW OUT
SERIES
RS485
RS485
TERMINATE
ON
OFF