Table of Contents
Advertisement
Only interchange the front and rear
#
wheels if the wheels and tyres have the
same dimensions.
Interchanging the front and rear wheels if the
wheels or tyres have different dimensions can
render the general operating permit invalid.
Observe the instructions and safety notes on
"Changing a wheel" (
page 557)
/
The wear patterns on the front and rear wheels
differ:
front wheels wear more on the tyre shoulder
R
rear wheels wear more in the centre of the
R
tyre
Do not drive with tyres that have too little tread
depth. This significantly reduces traction on wet
roads (aquaplaning).
On vehicles with the same front and rear wheel
size, you can interchange the wheels every
5,000 to 10,000 km, depending on the wear.
Ensure the direction of rotation is maintained for
the wheels.
Notes on storing wheels
When storing wheels, observe the following notes:
After removing wheels, store them in a cool,
R
dry and preferably dark place.
Protect the tyres from contact with oil, grease
R
or fuel.
Overview of the tyre-change tool kit
Apart from some country-specific variants, vehi-
cles are not equipped with a tyre-change tool kit.
Consult a qualified specialist workshop to find out
which wheel change tool is necessary and
approved for a wheel change on your vehicle.
You require the following tools, forexample, to
change a wheel:
Jack
R
Chock
R
Wheel wrench
R
Centring pin
R
%
The jack weighs approximately 3.4 kg.
F232 0017 02
Wheels and tyres 561
The maximum load capacity of the jack can
be found on the sticker affixed to the jack.
The jack is maintenance-free. If there is a
malfunction, please contact a qualified spe-
cialist workshop.
The tyre-change tool kit is located in tool bag
in the boot.
%
When stowing the tool bag, make sure that it
is adequately secured.
The tool bag contains:
Jack
R
Gloves
R
Wheel wrench
R
1
Advertisement
Table of Contents
