Memory Link Connections; Communicating With Other Devices; Ethernet/Ip - Omron NS8-TV0-V2 Setup Manual

1-2-6
1-2-7
1-2-8
Downloaded from Elcodis.com electronic components distributor

Memory Link Connections

When the host is a computer instead of a PLC, the Memory Link protocol can be used to
connect with the computer. Use serial port A or B to connect to the host. For details, refer to
the Host Connection Manual (Tem.Control, MemLink).

Communicating with Other Devices

The NS-series PTs can communicate with the following devices.
•
OMRON Trajexia Motion Controllers
•
Mitsubishi FX-series, A-series, and Q-series PLCs
•
Siemens S7-300-series PLCs
•
Yaskawa MP-series Machine Controllers
•
Yaskawa F7-series Varispeed and VS Mini V7-series Inverters
•
Rockwell Automation (Allen-Bradley) SLC50, MicroLogix, PLC-5, CompactLogix,
CompactLogix, and ControlLogix Controllers
•
Devices that support Modbus RTU
•
Yokogawa Electric FA-M3/FA-M3R-series PLCs
For details on connection methods, refer to the Host Connection Manual (Multivendor Con-
nection).

EtherNet/IP

EtherNet/IP is a multi-vendor industrial network protocol that uses Ethernet. The specifica-
tion is an open standard managed by the ODVA (Open DeviceNet Vendor Association), as is
DeviceNet, and it is used for a variety of industrial devices.
NS-series PTs can communicate with CS/CJ-series EtherNet/IP Units and
CJ2H-CPU@@-EIP CPU Units, which have a built-in EtherNet/IP port. Also, it is possible to
perform tag message communications if an NS-series PT is connected to a CJ2H PLC. The
CJ2H-CPU@@-EIP has a tag name server in the CJ2H-CPU@@-EIP Unit, so if a tag name
and address table is stored in advance, it is possible to perform access from the NS-series
PT using only the tag name.
1-2 Communications with the Host
1-7