Installation Method For Controller Link Interface Unit - Omron NS8-TV0-V2 Setup Manual

3-8-3
Downloaded from Elcodis.com electronic components distributor

Installation Method for Controller Link Interface Unit

This section explains the method for mounting a Controller Link Interface Unit to the PT.
The Controller Link Interface Unit can be mounted to NS15, NS12 and NS10 PTs only. It
cannot be mounted to an NS8 or NS5 PT.
• Do not touch the surface of the substrate or mounted devices with your bare
Precautions
for Safe Use
• After mounting the Controller Link Interface Unit to the PT, all fittings must
• Always turn OFF the power to PT before mounting or removing the Unit. Fol-
• When the Controller Link Interface Unit is installed, the depth of the PT will
• To install the Controller Link Interface Unit, secure sufficient space inside the
3-8 Installing the Controller Link Interface Unit
hands. Also, discharge static electricity from your body in advance.
be tightened with the provided screws. Tighten the screws to a torque of
0.6 N⋅m.
low the procedures and install the Unit correctly.
increase by 35 mm.
control panel beforehand.
3-47