Setting 1:1 Nt Link - Omron NS8-TV0-V2 Setup Manual

6-6 Communications Settings
terface is selected.
The use of the expansion interface is for future expansion and cannot yet be used. Always
use the serial port B connector. (The default setting is Disable.)
Status of the RS-232C/RS-422A Selector DIP Switch (NS15 Only)
A DIP switch can be used on the NS15 to change the communications protocol for serial port
B between RS-232C and RS-422A. Refer to 3-11 RS-232C/RS-422A Selector DIP Switch for
the switch setting procedure. The default setting is for RS-232C.
The current setting of the RS-232C/RS-422A selector DIP switch is displayed on the System
Menu as shown below.
6-6-2

Setting 1:1 NT Link

Select the Comm. Tab from the System Menu, and select NT Link 1:1 (1:1 NT Link) as the
communications method for serial port A or B.
After setting, press the Write Button to save the setting.
When 1:1 NT Link is selected, there are no details settings.
6-41
Downloaded from Elcodis.com electronic components distributor