Omron NS8-TV0-V2 Setup Manual page 270

Appendix 1 Specifications
A-10
Downloaded from Elcodis.com electronic components distributor
• Ethernet
Item
Network address 1 to 127
Node address 1 to 254
UDP port number 1024 to 65535 (See note 1.)
IP address 0.0.0.0 to 255.255.255.255 (See note 2.)
Subnet mask 0.0.0.0 to 255.255.255.255
Default gateway 0.0.0.0 to 255.255.255.255
IP proxy address ""(blank), 0.0.0.0 to 255.255.255.255
Conversion table Node address: 1 to 253
IP address: 0.0.0.0 to 255.255.255.255
Note 1. The default UDP port number is 9600.
2. Do not set the following values for the IP address.
• Host ID with all bits set to 0 or 1.
• Net ID with all bits set to 0 or 1.
• Subnet ID with all bits set to 1.
• IP addresses that begin with 127.
Controller Link Specifications (with NS-CLK21 Controller Link Interface
Unit Mounted)
Item
Communications method N:N token bus
Code Manchester code
Modulation Baseband code
Synchronization Flag synchronization (conforming to HDLC frames)
Transmission path type Multidrop (bus)
Baud rate and maximum The maximum transmission distances depends on the baud rate setting as fol-
transmission distance lows:
Media Specified shielded twisted-pair cable
2 signal lines and 1 shield
Connections to nodes PLCs:
Personal computers: Connected via special connector (provided)
Max. number of nodes 32 modes
Communications func- Data links and message service
tions
• Transmission area per node:
Number of data link
words
• Send/receive data link areas per SYSMAC CS-series PLC:
• Send/receive data link areas per SYSMAC C200HX/HG/HE, CVM1, or
CV-series PLC:
• Send/receive data link areas per personal computer:
• Total send data link words on entire network:
Data link areas Bit (CIO, and LR Area), data memory (DM Area), expansion data memory (EM
Area)
Message length 2,012 bytes max.
• Polling unit backup function
RAS functions
• Self-diagnosis (hardware check at startup)
• Internode tests and broadcast test (via FINS commands)
• Watchdog timer
• Error log
Error correction Manchester code check
CRC check (CCITT X
Note: A Controller Link Interface Unit can be used only for the NS15, NS12, and NS10 NS-
series PTs.
Specifications
(Example: 192.168.21.0)
(Example: 255.255.21.16)
(Example: 192.168.255.16)
(Example: 127.35.21.16)
Specification
2 Mbits/s: 500 m
1 Mbits/s: 800 m
500 Kbits/s: 1 km
Connected via terminal block
1,000 words max. (2,000 bytes)
12,000 words max. (24,000 bytes)
8,000 words max. (16,000 bytes)
32,000 words max. (64,000 bytes)
32,000 words max. (64,000 bytes)
16 12 5
+X +X +1)