Integration Of Simocode Pro In The Dp Master Systems; Slave Operating Modes; Preparing The Data Transfer - Siemens SIMOCODE pro System Manual

12.5

Integration of SIMOCODE pro in the DP master systems

12.5.1

Slave operating modes

The following table shows an overview of the slave operating modes which
SIMOCODE pro can be operated with on the class 1 master:
SIMOCODE pro
connected as:
• DPV1 slave
via GSD
• S7 slave via
OM
SIMOCODE pro
Table 12-8: Slave operating modes of SIMOCODE pro
12.5.2

Preparing the data transfer

In order to communicate with the class 1 master (PLC), a connection
according to
present and the PROFIBUS-DP address must be configured.
See Chapter
information about setting the address.
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
DP master
manufacturer-
independent,
without DPV1 alarms
• Cyclic data
exchange
• Standard
diagnostics
• Status information
• Parameterization
during startup (only
BU1)
• Acyclic writing and
reading of DPV1
data records (if
supported by the
master)
—
Table 12-8: Slave operating modes of SIMOCODE pro
14.2.2 "Setting the PROFIBUS DP address"
Class 1 master
DP master S7 master
manufacturer-
independent,
with DPV1 alarms
• Cyclic data
• Cyclic data
exchange
• Standard • Standard
diagnostics
• Status information • Status information
• Process and • Process and
diagnostic alarm
• Parameterization • Parameterization
during startup (only
BU1)
• Acyclic writing and • Acyclic writing and
reading of DPV1
data records
— • Cyclic data
• Standard
• Process and
• Parameterization
• Acyclic writing and
for more
Communication
exchange
diagnostics
diagnostic alarm
during startup (only
BU1)
reading of DPV1
data records
exchange
diagnostics
diagnostic alarm
during startup
reading of DPV1
data records
must be
12-17