Table of Contents
Advertisement
Assembly
Some sheet metal parts
may have sharp edges
that can cause minor cuts.
Please use care while han-
dling them.
The bandsaw is heavy and awkward to lift
onto the stand. Get assistance from another
person when lifting.
To assemble the bandsaw:
1.
Lay one stand side flat on a piece of card-
board to prevent scratching the paint, then
attach the upper and lower stand braces
to one side, as shown in Figure 8, with (8)
⁄
"-20 x
⁄
" hex bolts, (8)
1
5
4
8
(8)
⁄
"-20 flange nuts.
1
4
Note: Only hand-tighten the stand fasteners
during these initial steps. Once the stand is
completely assembled you will be instructed
to fully tighten all fasteners.
Upper
Stand Brace
Figure 8. Upper and lower stand braces
attached to the stand side.
-16-
⁄
" flat washers, and
1
4
Lower
Stand Brace
x 8
Stand Side
2.
Attach the remaining stand side to the assem-
bly, as shown in Figure 9, with (8)
hex bolts, (8)
⁄
" flat washers, and (8)
1
4
flange nuts.
Figure 9. Second stand side attached.
3.
Install the stand feet, as shown in Figure 10,
in the bottom of the stand assembly, using
a
⁄
"-16 x 2" stand foot, (2)
3
8
and (2)
⁄
" flat washers on each foot in the
3
8
sequence shown.
Note: Adjust the feet so that they are approxi-
mately the same height—this will make level-
ing the stand easier in a later step.
Figure 10. Stand foot installed (1 of 4).
G0555LX (Mfg. Since 3/13)
1
⁄
"-20 x
5
⁄
"
4
8
⁄
"-20
1
4
⁄
"-16 hex nuts
3
8
Foot
Hex Nut
Flat
Washer
Flat
Washer
Hex Nut
Advertisement
Table of Contents
