INSTALLATION AND OPERATION VERIFICATION
2-12. To install side stops:
Before removing covers from display
mainframe, disconnect line power by
removing ac power cord.
Remove side covers from bottom section of
mainframe. (Remove only right side cover if
mainframe is a rack-mounted model.)
Use flathead machine screws to install side
stops as shown in Figure 2-1.
Reinstall side covers on mainframe.
*
O N L Y ONE SIDE STOP A N D TWO SCREWS A R E USED FOR RACKMOUNT MODELS
--
FIGURE 2-1. LOCATION OF SIDE STOPS
4. Place label on front panel of spectrum analyzer
(upper right-hand corner) to indicate that the
plug-in is secured with side stops.
2-13. To remove side stops:
Before removing covers from display
mainframe, disconnect line power by
removing ac power cord.
Remove side covers from bottom section of
mainframe. (Remove only right side cover if
mainframe isa rack-mounted model.)
2. Remove side stops. See Figure 2-1.
3. Reinstall side covers on display mainframe.
08558-00094
MODEL 8559A
SCREW
2200-0 168