HP 8559A Operation And Service Manual page 183

Page 1- 3:
HP 85596 Specifications
Table
Below Change " Residual FMw s p e c i f i c a t i o n t o read a s follows:
Delete t h e following under "Maximum Input ( w i t h o u t damage)
Change "Gain Compression
Under *'Display F i d e l i t y
a s follows:
Change "Humidity Range (Operating)" t o read a s follows:
Change "EMIft t o read a s follows:
Below Change " Residual FMw s p e c i f i c a t i o n t o read a s f o l l o w s :
of 4)
l e s s than 1 kHz p-p f o r a time i n t e r v a l l e s s t h a n o r e q u a l t o
.O1 s e c , 100/120 l i n e v o l t a g e s ; l e s s than 2 kHz p-p, 220/240
l i n e v o l t a g e s .
Peak Pulse Power
+50 dBm (100W, 10 microsecond p u l s e width, 0.01% d u t y c y c l e )
with i n p u t a t t e n u a t i o n >=30 dB.
i s
Gain compression l e s s t h a n 0.5 dB f o r a 0 dBm i n p u t l e v e l
w i t h 0 dB i n p u t a t t e n u a t i o n .
<+-0.1 d i v i s i o n over f u l l 8 d i v i s i o n d e f l e c t i o n .
R.H. 0- degrees
C
Conducted and r a d i a t e d i n t e r f e r e n c e i s w i t h i n t h e requirements
o f methods CEO3 and RE02 o f MIL STD 461A, VDE 0871 and CISPR
P u b l i c a t i o n s 1 , 2, and 4.
l e s s than 1 kHz p-p i n 0.1 second.
w
s p e c i f i c a t i o n t o read a s f o l l o w s :
w
, change t h e Linear s p e c i f i c a t i o n t o read
t o +40-degrees
C.