TRENDnet User's Guide
ARP Inspection VLAN
Security > Dynamic ARP Inspection > VLAN
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Inspection VLAN
3. Select the VID List then its State. Click apply to save.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2023 TRENDnet. All Rights Reserved.
ARP Inspection Statistics
Security > Dynamic ARP Inspection > Statistics
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Inspection
Statistics
3. Select the VID List then click Clear.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
109