TRENDnet TPE-30284 User Manual page 36

TRENDnet User's Guide
7. Click on Edit for interface vlan1.
Note: All other functions of this page will be explained in detail in its respective section.
8. Configure the switch IP address settings to be within your network subnet, then click
Apply under the IP Settings.
9. When the confirmation message appears click OK.
Be sure to re-log back into the switch using the new IP address and save the
configuration to your flash.
© Copyright 2023 TRENDnet. All Rights Reserved.
NOTE: The configured settings are only applied to the switch's temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch's NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
1. At the bottom of the left hand panel, click Save.
2. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
6