Table of Contents
Advertisement
TRENDnet User's Guide
5. Review the settings. When you have completed making changes, click Apply to save
the settings.
•
Interface: Displays the VLAN that is currently being configured.
•
State: Select Enabled to enable IPv6 on this VLAN, and Disabled to disable on
this VLAN.
•
DHCPv6 Client: Select Enabled to automatically obtain the IPv6 address from
the DHCP server on the network, select Disabled to manually specify an IPv6
Address.
•
Rapid Commit: You can configure the switch to support the DHCPv6 Rapid
Commit option (DHCPv6 option 14). The server and client then use a two-
message exchange (Solicit and Reply) to configure clients, rather than the
default four-message exchange (Solicit, Advertise, Request, and Reply). The
two-message exchange provides faster client configuration, and is beneficial in
environments in which networks are under a heavy load.
•
IPv6 Address: Enter the full IPv6 address you would like to specify for this
connection.
© Copyright 2023 TRENDnet. All Rights Reserved.
•
NS Retransmit Time: A constant that defines a nonzero number of seconds
between periodic reauthentication of the client. The field is 1~3600 seconds.
The default setting is 1 second.
•
Delete: Click Delete to delete this entry.
6. At the bottom of the left hand panel, click Save.
7. Select the Config you would like to save the settings to, then click Save Settings to
Flash.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
18
Advertisement
Table of Contents
