Denial Of Service; Denial Of Service (Dos) - TRENDnet TPE-30284 User Manual

TRENDnet User's Guide
4. The MAC address will be added to the table.
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all of the entries in the table. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2023 TRENDnet. All Rights Reserved.

Denial of Service

Denial of Service (DoS)

Security > Denial of Service
The switch has built-in DoS prevention features to restrict specific type of traffic
associated denial of service attacks on your network. By default, all of the DoS settings
are set to Allow, which allow any type of traffic to pass through the switch. Setting one
of the items to Deny will set the switch to check for traffic matching the selected item
and deny any traffic matching the rule. On the other hand, setting one of rules to Deny
may deny a specific type of traffic that may prevent traffic essential to running your
network such as devices in load balancing configuration using virtual IP addresses (Ex. If
ARP MAC SA Mismatch is set to Deny, it may cause devices in load balance configuration
using shared virtual IP addresses communication issues essential for network server
load balancing.) For additional security, you can set these rules to Deny as necessary.
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on Security and click on Denial of Service.
PoE Web Smart Switch Series
101