TRENDnet TPE-30284 User Manual page 141

TRENDnet User's Guide
o
IPv4 Address- Indicates ACL action will be taken on packets to the
specified IPv4 source address.
o
IPv6 Address- Indicates ACL action will be taken on packets to the
specified IPv6 address.
•
Service Type- Defines the type of service.
o
Any- Indicates the ACL action will be taken on packets of all types of
service.
o
EtherType- Specifies EtherType packet filtering.
o
ICMP All- Specifies ICMP packet filtering.
o
IGMP- Specifies IGMP packet filtering.
o
TCP All- Specifies TCP packet filtering.
o
TCP Source Port- Matches packet to corresponding TCP Source Port.
o
TCP Destination Port- Matches packet to corresponding TCP
Destination Port.
o
UDP All- Specifies UDP packet filtering.
o
UDP Source Port- Matches packet to the corresponding UDP Source
Port.
o
UDP Destination Port- Matches packet to the corresponding UDP
Destination Port.
•
Action- Defines the ACL action linked to the rule criteria.
o
Permit- This selection allows ingress packets that conform to the
specified ACL criteria.
o
Deny- This selection drops ingress packets that conform to the
specified ACL criteria.
o
Rate Limiting- Activates rate limiting if all ACL criteria are met.
o
Replace DSCP- Enter a number in the Replaced-DSCP field within the
range of 0 to 63. This field indicates the DSCP level of interest. This
field is not mandatory and you may elect to leave it blank.
•
Ports- Defines the ports to be configured.
© Copyright 2023 TRENDnet. All Rights Reserved.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, then click Save Settings to
Flash,.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
PoE Web Smart Switch Series
111