Pitney Bowes DP50S Operating Instructions Manual page 42

3. Connecting the Printer Cables
Connecting to the standard Ethernet port
1. Attach the ferrite core supplied with this printer at the printer end of the Ethernet cable about 5 cm (2.5
inches) (
3
2. Connect the Ethernet cable to the Ethernet port that is located on the left side of the printer.
3. Connect the other end of the cable to the network, for example using a hub.
Connecting to the Ethernet port of the Gigabit Ethernet board
1. Attach the two ferrite cores to the Ethernet cable.
Attach the ferrite cores supplied with the Gigabit Ethernet board about 5 cm (2.5 inches) (
connector at both ends of the Ethernet cable, making a loop as shown.
40
) from the connector, making a loop as shown.
BBM011S
BMV182S
) from the