Pitney Bowes DP50S Operating Instructions Manual page 35

3. Unplug the cable from the Ethernet port, and then cover it with the protective cap.
4. Loosen the screw and remove the slot cover.
The removed cover will not be reused.
5. Remove the 5 screws securing the controller board.
The removed screws will be used to secure the controller board again later.
6. Holding the handle, carefully pull out the controller board.
Slide the controller board completely out, and then place it on a flat surface such as a table.
BMV160S
BMV161S
BMV268S
Installing the Interface Units
2
33