Installation On The Wall - Riello SC ACS 40 Manual

b
Installation and connection of the product must be
performed by an authorised, specialist company.
The company installing the product assumes all
responsibility for ensuring that the installation and
functioning of the product conform to applicable
standards.
b
The product must be stored in a dry place where it
is not subject to frost. The product must be installed
where it is protected against splashes of water. Am-
bient temperature in the place of installation must
not exceed 40°C during functioning of the product.
b
It is advisable to install the product as near as prac-
tically possible to the storage cylinder, in order to
avoid unnecessary heat loss from the connecting
pipes.
b
Handle with care!

INSTALLATION ON THE WALL

- Remove the product from its packaging and remove the
polypropylene cover.
- Slacken the 2 screws of the support jig (pic.2) and re-
move it from the back part of the module. Fix it on the
wall with nr. 2 screw anchors (12 mm not supplied) as
indicated in the ref.2
- Hook-up the module to the screws. Hook th module up
to the screws of the suppoort jig (see slot on the back)
using the lateral guide as indicated in the picture 3a.
- Slide down the module until the complete insertion of
the screws in the slot.
- Screwing the screws as indicated in the picture.
- Tighten the screws on the metal backplate through the
holes in the front of the product as shown in the figure.
- Connect the water pipes according to the schematic in
"System schematic".
- Check that all connections have been made correctly.
Make sure that the entire system is water tight before
putting the mixer into service. To ensure maximum ef-
ficiency, also make sure that all air has been bled from
the system.
- Fit the cover.
b
Check the correct connection of the module. Before
commissioning the module, make sure of the per-
fect tightness of the system. Also, for a good mod-
ule performance, provide for the total air outlet from
the system.
A
C
E
9
B
D