Table of Contents
Advertisement
10 Handling
Make sure that any lifting equipment is of adequate capa-
city to lift and move the storage tank.
Cut the straps (1) to remove the tank from the pallet.
On Riello 7000.1000/S e 1500/S models the straps are loca-
ted under the insulation at the hinges.
The storage tanks are fitted with a plug (2) into which you
can screw a lifting eyebolt (Ø 10 mm). Make sure that the
eyebolt is strong enough to lift the weight of the tank.
To lift Riello 7000.2000/F - 3000/F - 5000/F storage tanks,
first remove the insulation, then attach a rope of adequa-
te strength to the top of the tank before proceeding to lift
with great care.
Wear suitable personal protective equipment and
use suitable safety devices.
Do not leave packaging material within the reach of
children, since it can become a potential hazard.
11 Place of installation
Riello 7000 solar storage tanks can be installed in any room where there is no specific requirement for an electrical
protection rating higher than IP X0D.
The room where the appliance is installed must, however, be dry to prevent the formation of rust.
Respect the minimum specified installation distances to ensure correct installation and access for maintenance
12 Installation in older systems and systems requiring modernisation
When installing Riello 7000 solar storage tanks in old systems or systems requiring modernisation, always perform the
following checks:
- Make sure that the system is fitted with safety and control devices in accordance with applicable legislation and
standards.
- Make sure that the system has been flushed out to remove all sludge and lime scale, and has been vented and seal
tested.
Riello 7000.1000/S - 1500/S
1
Riello 7000.2000/F - 3000/F - 5000/F
1
9
Riello 7000
2
1
Advertisement
Table of Contents
