Installation On The Wall - Riello SC ACS 80 Manual

b
Installation and connection of the product must be
performed by an authorised, specialist company.
The company installing the product assumes all
responsibility for ensuring that the installation and
functioning of the product conform to applicable
standards.
b
The product must be stored in a dry place where it
is not subject to frost. The product must be installed
where it is protected against splashes of water. Am-
bient temperature in the place of installation must
not exceed 40°C during functioning of the product.
b
It is advisable to install the product as near as prac-
tically possible to the storage cylinder, in order to
avoid unnecessary heat loss from the connecting
pipes.

INSTALLATION ON THE WALL

b
Handle with care!
- Pull out the module from the package and remove the
cover.
- Fix No. 3 plugs (A) on the wall respecting the distance
as shown in rif. (B). Install the module on the the plugs
through the slots (C) on the back of the module. Slide it
down and fix the screws in the plugs.
- Screwing the screws (D)
- Replace the cover
b
Check the correct connection of the module. Before
commissioning the module, make sure of the per-
fect tightness of the system. Also, for a good mod-
ule performance, provide for the total air outlet from
the system.
A
D
9
C
B
45
C