Storage; Maintenance - Stamina inmotion 35-0123B Owner's Manual

STORAGE

1. To store the InMotion® Rower, simply keep it in a clean dry place.
2. To avoid damage to the electronics meter, remove the battery before storing the InMotion® Rower for
one year or more.
3. Grasp the FRONT STABILIZER(3) and REAR SUPPORT(1) to move the InMotion® Rower.
Do not use the SEAT(7) to move the InMotion® Rower. The SEAT(7) will move and the SEAT
CARRIAGE(5) may pinch your hand or fingers.

MAINTENANCE

The safety and integrity designed into the InMotion® Rower can only be maintained when the
InMotion® Rower is regularly examined for damage and wear. Special attention should be given to the
following:
1. Pull on the HANDLEBAR(6) and verify that the SHOCK(10) provides resistance.
2. Clean the roller tracks on the CENTER BEAM(2) with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(39) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(39) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components must be replaced immediately or the InMotion® Rower removed from
service until repair is made.
7. Only Stamina Products supplied components should be used to maintain/repair the InMotion®
Rower.
8. Keep your InMotion® Rower clean by wiping it off with an absorbent cloth after use.
13