Step 2: Up And Running - Juniper PTX10004 Manual

Switch State
1 On
Off
2 On
Off
3 On
Off
6. Plug the AC power cord into the power outlet.
7. If the AC power source outlet has a power switch, turn it on.
8. Turn on the power switch on the power supply.
9. If you're using two power feeds, verify that the 1 and 2 LEDs on the power supply faceplates are
steadily lit. These LEDs correspond to INP0 and INP1.

Step 2: Up and Running

IN THIS SECTION
Connect to the Router | 7
Set a Root Password and an Optional Hostname | 8
Configure the Default Gateway and Ethernet Interface | 9
Configure Optional Routes, Services, and Commit the Configuration | 9
Now that the PTX10004 is powered on, let's do some initial configuration to get the router up and
running on the network. It's simple to provision and manage the PTX10004 on your network.
Description
INP0 is present.
INP0 is not present.
INP1 is present.
INP1 is not present.
Enabled for 30-A feed; 5,000 W for single feed, 5,500 W for dual feeds.
Enabled for 20-A feed; power supply capacity is 3,000 W.
6