Table of Contents
Advertisement
7.
Move the lift away from the rack.
8.
Check the alignment of the router. The rack mount screws on each side of the rack should line up,
and the router should be level. Tighten the screws.
9.
Insert the safety restraint between the rear posts of the rack. It should rest on the top of the
chassis and align with the holes in the rack.
10. Attach the restraint to the rack by inserting six mounting screws through each flange hole and rack
hole and tightening the screws.
11. Install the line cards:
a. Remove the line card cover by grasping the handles and pulling straight out to expose the slot
for the line card. Save the cover.
b. Slide the line card all the way into the slot until the handle holes line up.
c. Rotate the handles simultaneously into the chassis until the card is fully seated and the handles
are vertical.
12. Install the optics and optional cable management system.
13. Lift the front door and line up the captive screws in the door with the holes in the chassis flange.
Attach the door to the chassis and rack using the captive screws. Turn the screws until they are
finger tight.
14. Have a licensed electrician attach the cable lug (provided in the accessory kit) to the grounding
cable.
15. Remove the two M6 screws with attached washers below the bottom power supply using a
Pozidriv or Phillips screwdriver.
16. Place the chassis grounding lug and cable over the screw holes with the cable connection pointing
to the left. Place the two screws with attached washers over the grounding lug and grounding
cable. Tighten the two M6 screws using a Pozidriv or Phillips screwdriver.
4
Advertisement
Table of Contents
