Hobart 100D20 Operation And Maintenance Manual With Illustrated Parts List page 9

OM-2032 / Operation and Maintenance Manual
100D20 / Generator Sets
When the referenced Figure appears in another Chapter/Section, the reference will include
the Chapter/Section number.
Example:
(Ref. 2-3; 1, Fig. 4) tells the user to refer to Chapter/Section 2-3, and to see item 1, in Figure
4.
Once a Figure number reference has been established for a series of instructional steps, the
Figure number is not repeated. Only the item numbers of parts involved are referenced.
For example, "Loosen screw (2, Fig. 6), slide out connector (4), and remove brush (6)".
When an item is referenced without a figure number, it will always apply to the last preceding
Figure number mentioned in the text.
NOTE 1:The word See may appear in some references, as (See Fig. 2). It means exactly the same
thing as Ref., however, its usage is more direct and definite.
NOTE 2:When an "output cable" is mentioned in the manual, it refers to a multiconductor cable
assembly. A five-conductor (A, B, C, N, and E or F) cable is required when delivering power
directly to an aircraft. A four-conductor (A, B, C, and N) cable may be used on a single output
machine when delivering power to a distribution box.
7. Customer Service
If you have any questions concerning your Hobart Power Systems Group equipment, you are
invited to contact our service department by mail, telephone, or FAX.
Write:
Telephone:
FAX:
March 28/94 Revised
Hobart Brothers Company
Airport Systems Group
Service Department
Troy, Ohio 45373, U.S.A.
(513) 332-5060 (Service)
(513) 332-5050 (Parts)
(513) 339-4219
Introduction
Page 3