OM-2032 / Operation and Maintenance Manual
100D20 / Generator Sets
e. Comply with conditions indicated in CONDITIONS column for the particular test being
performed.
f.
Press the pushbutton switch (2, Fig, 3) and observe voltage indicated by the voltmeter.
Compare to normal voltage indicated in VOLTAGE column.
g. Release pushbutton switch.
h. Repeat steps A thru G for other tests as required.
i.
When tests are completed, disconnect the test equipment and close canopy doors.
March 31/94 Revised
1. Selector Switch
2. Pushbutton Switch
3. Positive Test Jack (Red)
4. Negative Test Jack (Black)
5. Instruction Plate
Test Box Operating Controls
Figure 3
Test Receptacle
Connector (with
protective cap
installed)
Figure 4
Chapter 1-3
Page 9