Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface, set the parking
brake, shut off the engine, and remove the key.
2. Disconnect the negative battery cable; refer to your
Operator's Manual.
3. Open the hood.
Description
No parts required
Wire harness
Cable tie
Beacon bracket
U-bolt
Flange nut (3/8 inch)
Beacon socket
Beacon assembly
Rocker switch
Beacon-light decal
Fuse (10 A)
Fuse decal
No parts required
No parts required
Qty.
–
Prepare the machine.
1
Route the wire harness.
8
1
2
4
Install the beacon assembly.
1
1
1
Install the rocker switch.
1
1
Connect the wire harness to the
ground-block terminal and install the
1
fuse.
–
Connect the battery.
–
Test the beacon function.
2
Routing the Wire Harness
Parts needed for this procedure:
1
Wire harness
8
Cable tie
2
Use
Advertisement
