Toro GrandStand 133-1438 Installation Instructions

Electrical Accessory Port
GrandStand
Model No. 133-1438
Note: Determine the left and right sides of the machine from the normal operating position.
This product contains a chemical or chemicals known to the State of California to
Note: If your machine has a light kit and another electrical accessory installed, you need a Y harness (Toro Part No. 121-5988,
sold separately) to install this kit.
Installation
Installing the Electrical
Accessory Port
1. Shut off the engine, wait for all moving parts to stop,
engage the parking brake, and remove the key.
2. Remove the negative (-) battery cable from the battery.
3. Release the cushion.
4. Remove the knockout on the right side of the machine
(Figure 1).
1. Knockout location
5. Remove the locking ring from the 12 V receptacle.
6. Install the 12 V receptacle and secure it with the locking
ring (Figure 1).
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Mower
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Figure 1
2. 12 V receptacle
Register at www.Toro.com.
WARNING
CALIFORNIA
Connecting the Wire Harness
Connecting the Wire Harness
1. Install the post connectors from the wire harness to
the posts on the 12 V receptacle.
2. Connect the wire harness as follows.
•
Machines without any electric
accessories—connect the wire harness to
the machine main harness
1. Machine main harness
•
Machines with either a light kit or other
electric accessory—connect the wire harness to
the accessory connector on the light kit or other
accessory harness.
•
Machines with both a light kit and other
electric accessory—complete as follows:
Note: You need a Y adapter (Toro Part No.
121-5988, sold separately) to connect the wire
harness with both accessories installed on the
machine.
Form No. 3403-321 Rev A
Installation Instructions
(Figure
Figure 2
2. Wire harness
Original Instructions (EN) All Rights Reserved *3403-321* A
Printed in the USA
2).