Installation - Toro 144-1620 Manual

HD Drive Link Kit
Model No. 144-1620

Installation

Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Traction plate
Traction-cable bracket
Bolt
Nut
Traction rod
Preparing the Machine
1. Move the machine to level surface.
2. Shut off the engine, remove the key, and wait for
all moving parts to stop.
3. Disconnect the spark-plug wire.
Installing the Kit
Installing the Traction Plate and
Bracket
1. Remove the 2 screws that are holding the belt
cover in place (Figure
2. Remove the belt cover
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Qty.
–
1
1
2
2
1
1).
(Figure 1).
Register at www.Toro.com.
Prepare the machine.
Install the kit.
3. Unhook the spring from the existing traction
plate (Figure 2).
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3443-134 Rev A
Installation Instructions
Use
Figure 1
*3443-134*
g260066