Advertisement
1. Rocker-switch blades
5
Connecting the Wire Harness
to the Ground-Block Terminal
and Installing the Fuse
Parts needed for this procedure:
1
Fuse (10 A)
1
Fuse decal
Procedure
1. Insert the fuse (10 A) into the fuse block and apply the
fuse decal beneath the fuse block
1. Fuse block
2. Fuse decal
2. Connect the wire-harness-terminal ring to the
ground-block terminal
Figure 6
2. Female connector
(Figure
7).
Figure 7
3. Fuse (10 A)
(Figure
8).
1. Wire-harness-terminal ring 2. Ground-block terminal
6
Connecting the Battery
No Parts Required
Procedure
Connect the negative battery cable; refer to your Operator's
Manual.
7
Testing the Beacon
No Parts Required
Procedure
Push the rocker switch up to turn the beacon to the O
position.
Push the rocker switch down to turn the beacon to the O
position.
6
Figure 8
N
FF
Advertisement
