Toro GrandStand 133-1495 Installation Instructions

Strobe Light Kit
GrandStand
Model No. 133-1495
This product contains a chemical or chemicals known to the State of California to
Note: You must install the Light Kit (sold separately) before installing this kit.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Strobe-light assembly
Screw
Nut
Installing the Kit
1. Shut off the engine, wait for all moving parts to stop,
engage the parking brake, and remove the key.
2. Remove the negative (-) battery cable from the battery.
3. Remove the fuel tank; refer to the Operator's Manual for
the machine.
4. Feed the wire for 1 strobe light through the hole on the
side of the machine shown in
light with 2 bolts and 2 nuts.
Note: Repeat this step for the other strobe light on
the other side of the machine.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Mower
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Qty.
2
4
4
Figure 1 and secure the
Register at www.Toro.com.
Install the kit.
Left Side of the Machine Shown
1. Nut
2. Strobe light
Original Instructions (EN) All Rights Reserved *3403-101* A
Printed in the USA
Form No. 3403-101 Rev A
Installation Instructions
Use
Figure 1
3. Screw