Decorative Fronts - Heat & Glo LUX42 Installation Manual

Non-Combustible Zone
1/2 IN. BUILDING MATERIAL
(MAY BE COMBUSTIBLE)
NO COMBUSTIBLES
IN HATCHED AREA
2 X 4 ONLY IN
GRAY AREA
NOTE:
2 X 4 HEADER
CONFIGURATION
1 IN.
FACTORY-SUPPLIED
1/2 IN.
NON-COMBUSTIBLE
BOARD
Figure 10.11 Non-Combustible Zone
2 X 4 OR GREATER
FRAMING MATERIAL
PIPE IS FOR VISUAL
REFERENCE ONLY
3 IN.
= COMBUSTIBLES
NOT ALLOWED
Heat & Glo • LUX36, LUX42 Installation Manual
E. Decorative Fronts
A decorative front is required for this appliance. Only dec-
orative fronts certifi ed for use with this appliance model
may be used. The following decorative fronts are ap-
proved:
• FS-36-XX • LMOD-36XX
• FS-42-XX • LMOD-42XX
(X = color choice)
Decorative front fi nishing templates designed for use with
the LMOD Series decorative fronts are included with this
appliance. Decorative front fi nishing templates for the FS
Series decorative fronts may be ordered separately from
Hearth & Home Technologies dealers. See below.
DECORATIVE TOP
FRONT PART#
FS-36 2280-331
FS-42 2281-331
The decorative fronts approved for use with this appli-
ance have been designed to be installed by two methods:
Overlap Fit or Inside Fit. Before beginning the installation,
it is important to determine which method will be used.
Overlap Fit Decorative Fronts: These decorative fronts
have been designed to be installed over fi nishing material
that is less than one inch thick.
Inside Fit Decorative Fronts: These decorative fronts
may be recessed into non-combustible fi nishing material
up to 4 inches thick.
NOTICE: Proper clearances from the fi replace opening to
fi nishing material thicker than 1 inch MUST be maintained
when installing appliance in an inside fi t application. See
Figure 10.12.
NOTE: Finishing templates are included with this product.
See Section 10.A.
COMBUSTIBLE MATERIAL
NON-COMBUSTIBLE
B
A
DECORATIVE
FRONT TYPE
FS
LMOD
Figure 10.12 Required Clearance for Inside Fit Decorative Fronts
• 2287-980 Rev. L • 2287-980 Rev. L • 4/16
SIDE
QTY
PART#
1 2280-330
1 2281-330
BOARD
A B
3/4 IN. 1-1/4 IN.
1 IN. 3-1/4 IN.
QTY
2
2
45