Decorative Fronts - Heat & Glo 6000CLX-IFT-S Installation Manual

C. Decorative Fronts
Only decorative fronts certified for use with this appliance
model may be used. Contact your dealer for a list of dec-
orative fronts that may be used. Once you have deter-
mined what kind of decorative front and finishing material
is going to be used on the fireplace, you may use the
table below which shows the decorative front models and
the finishing material thickness allowed.
Note: Finishing strips may be used to aid in positioning
of non-combustible facing materials for some of the
facing and decorative front combinations specified
in the table above. They must be removed following
finishing work. See Figure 10.9.
DECORATIVE
FIT
FRONT
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Chateau Forge
Inside
Overlap
Galleria
Inside
CF Inside
Iron Age Inside
FINISH MATERIAL
THICKNESS FIGURE
0-6 inches max.
1 inch or less
1-6 inches max.
1 inch or less
1-6 inches max.
1 inch or less
1-6 inches max.
1 inch or less
1-6 inches max.
1 inch or less
1-6 inches max.
0-6 inches max.
0-6 inches max.
Heat & Glo • 6000CLX-IFT, 8000CLX-IFT Installation Manual • 2506-980 Rev. B • 3/18
Finishing Material:
1 Inch Thick or Less
Remove Finishing Strips. See Figure 10.9.
NOTICE: Remove finishing strips before firing appliance.
DOOR
Finishing materials 1 inch maximum thick.
SEE
Stop finishing material flush with opening.
10.8
10.6
10.7
10.6
10.7
10.6
10.7
10.6
10.7
10.6
10.7
10.8
10.8
Figure 10.6 Finishing Material 1 Inch Thick or Less
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
FINISHING STRIP NOT USED
(See Figure 10.9 for
removal instructions)
NON-COMBUSTIBLE
FINISHING MATERIAL
53