Rls Authentication - Canon imageCLASS LBP6780dn Service Manual

2
Technology > MEAP > System Application Management > RLS Authentication

■ RLS Authentication

Login without using the SMS login window but by entering the user ID and password for
authentication in the RLS (Remote Login Service) window. The user information (user name
and password) used is the information for server authentication or local device authentication.
The login procedures are as follows.
1) Access SMS by RLS Authentication from the PC browser on the same network as the
MEAP device.
URL: https://<IP address of MEAP device>:8443/sms/rls/
Ex.) https://172.16.188.240:8443/sms/rls/
Note:
To encrypt the password information input when logging in, SSL of the login screen
was made effective. However, it is redirected to new URL (effective SSL) even when
accessing with URL (non-SSL) before.
Note:
• When the device authentication method used is server authentication, enter the user
name, password and login destination registered with authentication server and then click
'Log In'.
• If the authentication method used is local device authentication, enter the user name,
password and login destination registered in the device and click 'Log In' button.
The user information is set as below for local device authentication by default. Both are
case sensitive.
- User Name: Administrator
- Password: password
2 Technology > MEAP > System Application Management > RLS Authentication
Note:
Only the following users may us SMS via RLS.
• For local device authentication, users with Administrator or Device Admin authority.
• In the case of server authentication, the users who belong to the group (default:Canon
Peripheral Admins) specified as the device administrator on the SSO-H Configuration
screen.
Note:
SMS Access can be gained also from Remote UI.
Access Remote UI and click on SMS shortcut shown on the lower right of the screen to
gain access to SMS.
When only the password authentication is enabled, the password authentication screen
is shown.
When only the RLS authentication is enabled, no further authentication is needed to
access SMS. This is because users have already authorized upon accessing to Remote
UI.
F-2-149
2-70
F-2-150
F-2-151
2-70