System Management Operations; Various Setting - Canon imageCLASS LBP6780dn Service Manual

5
Troubleshooting > Updater > System Management Operations > Various Setting

System Management Operations

■ Various Setting

Setting Log Level
This section describes how to set system log levels.
1. Activate [Register/Updater Software (Management Settings)] from browser.
1). Enter [https://machine's IP address:8443/svm/] to the URL of browser.
2). Type the password [*28*] then log in it.
3). After login, select [System Settings] > [Edit].
2. Select a log level from [Log Level] dropdown list.
• [Log Level]:
Select one of 5 levels ranging from [0] to [4]. (The default [3].)
See the table below for logs output in each level.
5 Troubleshooting > Updater > System Management Operations > Various Setting
Log Level
Trace
0 -
1 -
2 -
3 -
4 Yes
NOTE:
This list shows the contents of the Log Output.
Log Output
Trace
Information
Important Message
Ordinary Error
System Error
F-5-57 3. Press [Configure] button to set the selected log level. Now the log level is successfully set.
Caution:
When you set it to log level 4, a performance falls, and the log acquisition takes time
remarkably .
F-5-58
Log Output
Information Important Message Ordinary Error
- -
- - Yes
- Yes Yes
Yes Yes Yes
Yes Yes Yes
Description
Detailed logs for debug
Logs related to operations done on the system
Update logs output by firmware type
Installation logs by MEAP application
Logs related to enabled functions by system option
Logs for ordinary errors
Logs for internal system errors
5-42
System Error
- Yes
Yes
Yes
Yes
Yes
T-5-52
5-42