Toro 03606A Operator's Manual page 37

6. Engage the parking brake.
7. Set the throttle to the low I
Performing a Parked Regeneration
Note:
For instructions on unlocking protected menus,
refer to Accessing Protected Menus (page
1. Access the protected menu and unlock the
protected settings submenu
Accessing Protected Menus (page
Figure 42
2. Navigate to the M
button to scroll down to the S
press the right button to select the S
option (Figure 43).
Note:
The InfoCenter should display the PIN
indicator in the upper right corner of the display.
Figure 43
3. In the S M
ERVICE
until the DPF R
EGENERATION
and press the right button to select the DPF
R option
EGENERATION
position.
DLE
24).
(Figure 42); refer to
24).
M , press the center
AIN ENU
M
ERVICE ENU
ERVICE
, press the middle button
ENU
options displays,
(Figure 44).
4. When the "Initiate DPF Regen. Are you sure?"
message displays, press the center button
(Figure
g028523
, and
5. If the coolant temperature is below 60°C (140°F)
the "Insure
message displays.
Observe the temperature in the display, and run
the machine at full throttle until the temperature
reaches 60°C (140°F), then press the center
button.
g212371
Note:
If the coolant temperature is above 60°C
(140°F) this screen is skipped.
37
Figure 44
45).
Figure 45
is running and above 60C/140F"
(Figure 46).
g212138
g212125