Table of Contents
Advertisement
6.
Lower all lift arms completely.
7.
Remove the snapper pin and the cap from the
lift-arm-pivot yoke
Figure 10
1. Snapper pin
8.
For the front cutting units, slide a cutting unit
under the lift arm while inserting the carrier-frame
shaft up into the lift-arm-pivot yoke
Figure 11
1. Lift arm
2. Carrier-frame shaft
9.
Use the following procedure on the rear cutting
units when the height of cut is above 1.9 cm
(3/4 inch).
A.
Remove the lynch pin and washer securing
the lift-arm-pivot shaft to the lift arm and
slide the lift-arm-pivot shaft out of the lift
arm
(Figure
12).
(Figure
10).
2. Cap
(Figure
3. Lift-arm-pivot yoke
1. Lynch pin and washer
B.
Insert the lift-arm yoke onto the carrier-frame
shaft
C.
Insert the lift-arm shaft into the lift arm and
g003975
secure it with the washer and lynch pin
(Figure
10.
Insert the cap over the carrier-frame shaft and
lift-arm yoke.
11.
Secure the cap and the carrier-frame shaft to the
lift-arm yoke with the snapper pin
11).
Note:
Use the slot if a steering cutting unit is
desired or use the hole if the cutting unit is to be
locked in position
12.
Secure the lift-arm chain to the chain bracket
with the snapper pin
Note:
Use the number of chain links described
in the Operator's Manual for the cutting unit.
g003977
1. Lift-arm chain
13.
On cutting unit 4 (left front) and cutting unit 5
(right front), insert the reel-motor hoses into the
respective hose guide.
14.
Coat the spline shaft of the reel motor with clean
grease.
15.
Oil the reel-motor O-ring and install it onto the
motor flange.
16.
Install the motor by rotating it clockwise so that
the motor flanges clear the bolts
16
Figure 12
(Figure
11).
12).
(Figure
13).
Figure 13
2. Chain bracket
g003979
(Figure
10).
g003948
(Figure
14).
Advertisement
Table of Contents
