Toro 03606A Operator's Manual page 15

Note:
When installing or removing the
cutting units, make sure that the hairpin
cotter is installed in the spring-rod hole next
to the rod bracket. When not installing or
removing the cutting units, the hairpin cotter
must be installed in the hole in the end of
the rod.
Figure 7
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. Hose guides must lean toward the center cutting unit.
g030896
5. Cutting unit 5
6. Reel motor
7. Weight
1. Hose guide (cutting unit 4
shown)
2. Rod bracket
Figure 9
15
Figure 8
3. Nut
g015160
g019284