Pairing With Audio Source; Switching “Bluetooth Connection” Flashing On/Off - Sennheiser PX 360 BT Instruction Manual

Putting the PXC 360 BT into operation
1
5
1
1
3s
1
1
5
14
Pairing the PXC 360 BT with your audio source
Make sure that your headphones are switched off (see
"Switching the PXC 360 BT on/off" on page 12).
When switching the headphones on
cally go into pairing mode. The headphones are waiting to be paired with
a Bluetooth enabled device (see page 13).
Press the Master
alternately flashes blue and red.
On your audio source, activate the Bluetooth function "Add a new
device".
Proceed as described in the instruction manual of the audio source.
If a suitable audio source is found, the devices will exchange device identi-
fication information. The
ascending beep. The devices have identified each other and the head-
phones are paired with the audio source.
PIN code
When the audio source prompts for a password or PIN code, enter
the default PIN code "0000".
If a connection is established, the
If no device is found within approx. 5 minutes, the
3 times red and you hear a descending beep. The headphones will then try
for 3 minutes to connect to one of the up to 8 previously paired audio
sources. If this fails, the headphones automatically switch off after
60 minutes.
In this case, repeat the necessary steps to pair the headphones with
your audio source again.
Switching the "Bluetooth connection" flashing on/off
Switch the headphones off (see "Switching the PXC 360 BT on/off" on
page 12).
To switch the flashing
Press the Master
alternately flashes blue and red.
Briefly press the Volume
6 To switch the flashing
Briefly press the Volume
3
for the first
button and keep it pressed until the
LED flashes 3 times blue and you hear an
LED continues to slowly flash blue.
on during a Bluetooth connection:
button and keep it pressed until the
button .
off during a Bluetooth connection:
button .
time, they will automati-
LED
LED flashes
LED