Pairing With An Audio Source; Switching Bluetooth Connection Flashing On/Off - Sennheiser MM 550 Instruction Manual

1
5
1
1
1
5
6
3
Pairing the MM 550 with an audio source
Make sure that your headset is switched off (see "Switching the
MM 550 off" on page 11).
When switching the headset on
into pairing mode. The headset is waiting to be paired with a Bluetooth
enabled device (see page 12).
Press the Master button
alternately flashes blue and red.
On your audio source, activate the Bluetooth function "Add a new
device".
Proceed as described in the instruction manual of the audio source.
If a suitable audio source is found, the devices will exchange device identi-
fication information. The
ascending beep. The devices have identified each other and the headset is
paired with the audio source.
PIN code
When the audio source prompts for a password or PIN code, enter
the default PIN code "0000".
If no device is found within approx. 5 minutes, the
3 times red and you hear a descending beep. The headset will then try for
3 minutes to connect to one of the up to 8 previously paired audio sources.
If this fails, the headset automatically switches off after 60 minutes.
In this case, repeat the necessary steps to pair the headset with the
audio source again.
Switching the "Bluetooth connection" flashing on/off
Switch the headset off (see "Switching the MM 550 off" on page 11).
To switch the flashing on during a Bluetooth connection:
Press the Master button
alternately flashes blue and red.
Briefly press the Volume
To switch the flashing off during a Bluetooth connection:
Briefly press the Volume
Putting the MM 550 into operation
for the first time, it will automatically go
and keep it pressed until the
LED flashes 3 times blue and you hear an
and keep it pressed until the
button .
button .
LED
LED flashes
LED
13