Remove Control Card - Cisco NCS 1001 Hardware Installation Manual

Hide thumbs Also See for NCS 1001:

Table of Contents

Remove Control Card

Procedure

Step 1

Insert the control card in the NCS 1001 box guides.

Step 2

Slide the control card while keeping the ejector open until the faceplate is close to the box and the ejector is

engaged.

Step 3

Press the ejector to insert the control card partially.

Step 4

Apply pressure on the control card faceplate to complete the insertion.

Step 5

Ensure that the control card faceplate is aligned to the top cover edge of NCS 1001.

Step 6

Verify that the position of the ejector is final.

Step 7

Fix the screw to lock the ejector.

Step 8

Push the fan tray inside the chassis.

Step 9

Ensure that the captive screws are aligned properly and fasten the captive screws.

Step 10

Insert the fans inside the cage. See

Note

Hardware Installation Guide for Cisco NCS 1001

The control card is not properly seated. Repeat the instructions mentioned in callout 2 to push the

control card.

The inlet temperature of system during replacement must be less than 40 deg Celsius at sea level. The

replacement time decreases for higher altitudes.

In case of card failure, the failed control card needs to be physically replaced within 2 minutes. Otherwise,

the performance of the system is affected.

Insert Fans, on page

43.

Replace Cisco NCS 1001 Components

Table of Contents