Cisco NCS 1001 Hardware Installation Manual page 11

Cisco NCS 1001 Overview
• Booster amplifier (COM-RX to LINE-TX) - True variable gain booster amplifier
• ADD/DROP OSC channel supports both 1510nm and 1610nm +/-10nm
• OCM assesses channel presence and Gain regulation and per channel power monitoring.
Figure 8: EDFA Front View
1
2
3
4
5
The following table describes the mapping of controllers and optical ports for the optical amplifier module.
Controller
Ots 0/slot/0/0
Ots 0/slot/0/1
• Range # 2: 20 to 34 dB gain, Tilt control: 34 to 37 dB gain, with tilt uncontrolled
• 23dBm output power @ COM-TX port
• Gain range: 1 to 20. 20 to 25 uncontrolled tilt.
• 23dBm output power @ LINE-TX port
XFP for OSC and additional OTDR feature
SFP for OSC (Optical Service Channel)
Status LED
Service Channel input and output port [OSC - RX, TX]
PRE and BST amplifier inputs and output ports
[L (LINE) - RX, TX]
[C (COM) - RX, TX]
[COM - TX CHECK]
Optical Ports
• COM-RX (booster input)
• COM-TX (preamplifier output)
• LINE-RX (preamplifier input)
• LINE-TX (booster output)
Hardware Installation Guide for Cisco NCS 1001
Optical Amplifier Module
7